Discraft Nuke

[Chuck Kennedy]

New wide winged driver by Discraft approved 10-31. Could be a Halloween treat!

http://www.pdga.com/tech-standards

[JimW]

I will be highly disappointed if we don't see pictures of a Duke Nukem dye in the Disc Artwork forum within 4 months of its release.

[JimW]

Code: Select all

Maker           Mx wt  Diam   ht   rim    rim    rim   rm dpth     rm config    flexibility
Discraft Nuke   176.0   21.2   1.5  1.2   16.2   2.5   5.7          28.25        9.87
Innova Boss     176.0   21.2   1.5  1.2   16.2   2.5   5.7          26.00        7.60
Innova Katana   176.0   21.2   1.8  1.2   16.3   2.5   5.7          26.25        10.32


So...it's a Boss.

[discspeed]

Chuck...if you're out there...

Could you explain what the rim configuration is exactly?

[discspeed]

I'm betting that its going to be a touch more HSS than a Boss.

[Booter]

New wide winged driver by Discraft approved 10-31. Could be a Halloween treat!

http://www.pdga.com/tech-standards

if i get one ill throw that on the damn thing just cause i love duke nukem

[Chuck Kennedy]

Rim Configuration is essentially the sharpness of the rim. The sharper the rim, the smaller the number. Here's how it's measured:

"The rim of the disc is held perpendicular to a contour gauge having 13 probes per cm (such as the Valued ST142). The rim of the disc is then pressed gradually into the gauge to a depth of 5 mm. The resulting movement of each affected probe is measured to the nearest 0.25 mm, and then totaled to produce the rim configuration rating. The ratings of three samples are determined, and the median score is used as the final rating."

So, the low height drivers don't engage as many probes in the gauge as say a Roc or Zephyr.

[JimW]

There's a minimum rim config but no maximum, so I assume that requirement is there to prevent discs from having rims so sharp that they could be highly dangerous both to the hand that throws them and anyone that might get hit by one?

[Jester_da1]

Code: Select all

Maker           Mx wt  Diam   ht   rim    rim    rim   rm dpth     rm config    flexibility
Discraft Nuke   176.0   21.2   1.5  1.2   16.2   2.5   5.7          28.25        9.87
Innova Boss     176.0   21.2   1.5  1.2   16.2   2.5   5.7          26.00        7.60
Innova Katana   176.0   21.2   1.8  1.2   16.3   2.5   5.7          26.25        10.32


So...it's a Boss.

If I am reading this right it has a slightly blunter nose than a Boss and is more flexible. I would assume this would make it slightly slower and have more stability. A faster Xcal?

[JKP]

faster force =)

[discspeed]

A faster Xcal?

A faster Force...though from Discraft Mike's description its not supposed to be particularly overstable as he compared it to a Flash and Surge I think.

[JKP]

faster surge or flash would make it flippier than a boss?

[Chuck Kennedy]

No one knows exactly how sharp is too sharp. It's not like it was measured in some sort of safety test whatever that would be. I believe the Eclipse approved in 1989 may have been the benchmark for setting the minimum because its value is 26 which is still the allowable minimum.

[Aaron_D]

probably about the same. I always thought the boss was pretty much the flippiest of the highspeed drivers, but is also the fastest, so it is speed stable for most. The boss reminds me of a fast Orc while the force reminds me of a fast starfire.

lol @ rim configuration as a concept.

[discspeed]

faster surge or flash would make it flippier than a boss?

Its hard to say because Flashes are all over the place stability-wise. Surges don't really have a high speed turn when new unless you really push them past their cruising speed. Boss seems to flip inside of its cruising speed. In other words, the Boss is only flying its fastest while flipping, where the Surge only flips when thrown faster than it is meant to fly.