Moderators: Timko, Solty, Frank Delicious, Blake_T, Fritz, Booter
JHern wrote:Interesting tips. Good emphasis on grip and getting legs/hips into it, and keeping the elbow close. I agree with a lot of what you said.
The firm vs. loose, wrist roll vs. no wrist roll (respectively), I have to think about a bit. This might also depend on how low the pull line is.
ChrisWoj wrote:JHern wrote:Interesting tips. Good emphasis on grip and getting legs/hips into it, and keeping the elbow close. I agree with a lot of what you said.
The firm vs. loose, wrist roll vs. no wrist roll (respectively), I have to think about a bit. This might also depend on how low the pull line is.
You're right now that I think about it, although I really need to be throwing a high angle release to keep my wrist firm through the motion. I know I usually keep it firm through rollers.
JHern wrote:ChrisWoj wrote:JHern wrote:Interesting tips. Good emphasis on grip and getting legs/hips into it, and keeping the elbow close. I agree with a lot of what you said.
The firm vs. loose, wrist roll vs. no wrist roll (respectively), I have to think about a bit. This might also depend on how low the pull line is.
You're right now that I think about it, although I really need to be throwing a high angle release to keep my wrist firm through the motion. I know I usually keep it firm through rollers.
Brad Walker also makes a good point about the forehand in his Snap 2009 thread. Basically, it is that one should try to throw the outside edge of the disc as if it were a hammer, instead of throwing through the middle of the disc. Each time I do this, my fingers snap off the rim and into my palm at release...and the throw is typically doing exactly what I wanted to do after release.
ChrisWoj wrote:JHern wrote:ChrisWoj wrote:JHern wrote:Interesting tips. Good emphasis on grip and getting legs/hips into it, and keeping the elbow close. I agree with a lot of what you said.
The firm vs. loose, wrist roll vs. no wrist roll (respectively), I have to think about a bit. This might also depend on how low the pull line is.
You're right now that I think about it, although I really need to be throwing a high angle release to keep my wrist firm through the motion. I know I usually keep it firm through rollers.
Brad Walker also makes a good point about the forehand in his Snap 2009 thread. Basically, it is that one should try to throw the outside edge of the disc as if it were a hammer, instead of throwing through the middle of the disc. Each time I do this, my fingers snap off the rim and into my palm at release...and the throw is typically doing exactly what I wanted to do after release.
That depends entirely on the purpose of the forehand. If you want short and accurate forehands you adjust that closer to the center of the disc. Longer shots require the additional leverage of throwing through the far point on the disc.
tigel wrote:I liked the video, I wish you made this 5 months ago when I had all these questions when I started playing disc golf. Now I know everything that was said, but a nice reminder, especially on the run up.
My problem is I throw forehand rollers, a LOT. It's one of my favorite throws. I throw both extremely anhyzer angled overstable runners and also flat/slight anhyzer understable rollers that go 100ft then start rolling. The amount of torque/OAT I put on these throws is crazy, BUT I'm consistent and successful in these throws every time. What I'm finding is when I try and throw normal sidearm upshots or drives I tend to put too much arm in my throws and usually end of throw at an anhyzer angle. Today for the hell of it I threw all my drivers forehand. I used to bomb forehand before I started throwing backhand. Every throw just went left. It felt like it was my first week playing again. Even with the knowledge I have on proper form and stuff, I still wasn't able to twink my form today to get a successful throw.
I don't know if I should learn how to throw my rollers for finesse like, which totally ruins the 3 months I've been working on them. Or should I keep working on my forehands and power through the "tough times" I'm experiencing? I just don't know if I can manage to control my OAT that I use for my rollers, when I throw normal.
Firios wrote:Great vid. I use a very strange grip that clearly is poor for distance, but I am extremely consistent with it within the 100-250 range. This will definitely be watched a few times when I decide to try and work on some long range forehand form. It would be nice to see some field demonstrations in addition to the explanation, as it is always easier to listen to advice when you can see the throwing form right after, or at the same time.
Users browsing this forum: No registered users and 2 guests