DGDave's Dyed Disc Depository

[victorb]

Just turned this out for victorb

FK YES

Next I'm going to have you do the blue version of the logo

[dgdave]

Here's a job I just did for ziggy.



The bottom right is a design I did for him. He wanted a Silent Chainbiter and with a little colabo, here's what we ended up with

[malinkie]

Awesome

Love the turtles

[dgdave]

Here's a set I just did for jnecessary



Here's a close up of a new design.

[dgdave]

A couple for BLURR

[jnecessary]

Can't wait to get 'em back even if they will do more spinning on my finger on the couch and spinning in the air for the next couple months

[malinkie]

What do you use for your 3d designs? and how do you get such clean edges so close to / off the edge of the disc?
Good work!
-Mal

[dgdave]

I use inkscape for 99% of my imaging. As for getting close tobthe edge, I lay the disc down on the stencil and press it on through the back of the disc before I lift it up without pressing the edges down. Then, I flip the disc and go around the edges with my.hands getting it stuck on there. Then I go over the whole thing with a squeegee. I also take the transfer tape off from the middle out.

[eky8]

I also take the transfer tape off from the middle out.

That right there is a good idea. Never thought of that. I'll have to try it. Thanks.

[veganray]

I need this on a Vibram Ridge, with the obvious use of the Vibram logo. Any takers?

[dgdave]

I could do something. It would be a few weeks though.

[dgdave]

[dgdave]

Here's a pack for Chris Hysell. Got one more to do

[newyorkmike]

uld you dye me a z buzzz which i can send you with the sac. kings and i would pay you in platics of your choice

[dgdave]

What do ya guys think of my updated logo?